43
Installation Instructions
INSTALLING THE ANTI-TIP
DEVICE
A.
Mark the wall where the
RIGHT EDGE
of the range
is to be located. Be sure to allow for the countertop
overhang if you intend to install the range next to
cabinets.
B.
Locate the outside edge of the device 2
1
⁄
8
″
toward
the center of the range from the marked edge of
the range.
C.
Using the device as a template, mark the position of
the hole for the screw.
D.
For wood construction, drill a pilot hole at an angle
of 20 degrees from the horizontal. A nail or awl
may be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you will need
a 1/4
″
x 1
1
⁄
2
″
lag bolt and a 1/2
″
O.D. sleeve anchor,
which are not provided. Drill the recommended size
hole for the hardware.
9
INSTALLING THE ANTI-TIP
DEVICE
(CONT.)
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolts must be
properly tightened as recommended for the hardware.
E.
Slide the range against the wall, and check for proper
installation by grasping the front edge of the cooktop
and carefully attempting to tilt the range forward.
9
WHEN ALL HOOKUPS ARE
COMPLETED
Make sure all controls are left in the off position. Make
sure the flow of combustion and ventilation air to the
range is unobstructed.
WARNING!
■
Range must be secured with an approved Anti-Tip
device.
■
Unless properly installed, the range could be tipped
by you or a child standing, sitting or leaning on an
open door.
■
After installing the Anti-Tip device, verify that it is in
place by carefully attempting to tilt the range forward.
■
This range has been designed to meet all recognized
industry tip standards for all normal conditions.
■
The use of this device does not preclude tipping of
the range when not properly installed.
■
If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB2X7909.
