GE JB450GP, Инструкция по использованию, уходу и установке

Страница: 29 / 36

The Problem
(continued)
PROBLEM
CLOCK AND
MINUTE/SECOND
TIMER DO NOT WORK
SURFACE
NOT FUNCTIONING
PROPERLY
OVEN WILL NOT
SELF-CLEAN
OVEN DOOR WILL
NOT UNLOCK
OVEN NOT CLEAN
AFTER CLEAN CYCLE
“door” APPEARS ON DISPLAY
CONTROL BEEPS AFTER
ENTERING OVEN TIME
OR STOP TIME
“F-” AND A NUMBER
FLASH ON DISPLAY
POSSIBLE CAUSE AND REMEDY
. Make sure the electrical plug is plugged into a live, properly grounded
power outlet.
●
Check for power outage.
Review Control, Clock Timer section this book.
Surface units are not plugged in solidly.
●
Trim rings and drip pans are not set securely in the range top.
●
Surface unit controls are not properly set.
. Oven temperature is too high to set self-clean operation. Allow the range to
cool to room temperature and reset
controls.
Door latch handle not moved all the way to the right.
●
Oven must cool below locking temperature (approximately 30
minutes after
the clean cycle is complete).
●
Oven controls not set properly.
●
Heavily soiled ovens require 3 to 4-hour Clean Time.
●
Heavy should be cleaned up before starting clean cycle.
●
Self-clean cycle has been selected but latch was moved all way
to the right. Move handle.
●
Latch handle was moved to the right but another program other than self-clean
was selected, Move
latch handle to the right only when setting self-clean
This is reminding you to enter a bake temperature.
●
This is the function error code. If function error code appears during the
clean function, check oven door latch—the latch handle may have been moved,
even if only slightly, from the latched position. Make sure latch is moved to the
right as far it will go. Touch CLEAR/OFF pad. function error code does
not clear, disconnect power to the range and call for service.
If you need more help... call, toll free:
GE Answer
800.626.2000
consumer information service
29