GE Innova Series, Руководство пользователя

Страница: 23 / 54

b. Use Ardex P–82 on non porous floors such as terrazzo, ceramic tile, sealed concrete
and epoxy coated.
4. Apply a coat of primer with a sponge or brush on the area to be grouted.
5. Remove all puddles with cloth or brush.
6. Allow primer to dry a minimum of one hour before beginning grouting procedure.
7. Construct a foam dam according to the appropriate Installation Directions.
2.4.1.4 Grouting
1. Plug the bolt holes in the floor with wood dowels. Wrap the dowel ends in tape to prevent grout
from getting into the anchor holes if holes are larger than the dowels.
NOTE: Do not use grease on the dowels, as this may keep the anchor from setting.
2. Seal the cracks around the wood dowels with clear RTV 108 silicone rubber compound before
grouting.
NOTE: It is recommended to lightly lubricate the foam tape for easy removal after the grout pad
has set.
3. Construct a dam with adhesive foam tape along the outline previously marked on the floor.
4. Dampen the area to be grouted with water.
2.4.1.5 Grout Preparation Procedure
Ardex K–15 when mixed with water becomes a liquid compound which seeks its own level and
automatically produces a smooth and flat surface. This grouting procedure is recommended for
use with X–Ray tables and positioners. It will also fill voids by capillary action.
1. For mixing, four environmental factors that must be controlled to maintain a 10 minute grout
flow period:
a. Floor surface must be cool, primed and cleaned.
b. Air temperature should not exceed 70°F (21°C).
c. Grout powder should be allowed to cool to room temperature if brought in from a hot
vehicle.
d. Water temperature should be 70°F (21°C) or cooler. Chilled water may be used to
slightly compensate for the 3 previous steps.
2. Remove plastic bag containing Ardex K–15 powder from the mixing pail.
3. Install the Ardex T–2 mixing paddle in the 1/2 inch drill.
NOTE: Never use warm water; it shortens the grout flow time.
Single Plane and Biplane Innova Systems Pre–Installation Kit Installation Procedures
GE Healthcare Direction 2290880-12-1EN, Revision 1
Chapter 1 Installation Procedure 23