GE Protimeter Hygromaster
Page 18
6
Logging Functions - Manual Logging (Recording)
Note:
It is recommended that the clock is checked before performing manual logging.
1.
Use
as described above to scroll to the time/date display. The clock must be set from
the PC as described above whenever the batteries are replaced.
2.
With the instrument
OFF
, press and hold
for 3 seconds to take a manual log point.
This behaves exactly as if the logging were performed using the timer as above. There is no
requirement for logging to have been enabled first, although it may be useful to set the job
number.
3.
Similarly, with the instrument
ON
, press and hold
for 3 seconds to take a manual log
point. In this case, note that the side port must be previously set in
“surface temperature”
mode if this input is to be used. Again there is no requirement for logging to have been
enabled first, although it may be useful to set the job number.
