GE Protimeter Hygromaster
Page 16
5
Logging Functions - PC Setup
To log the functions and setup the PC, do the following:
1.
Connect the sensors as described previously and confirm correct operation.
2.
Unplug the surface temperature sensor, if fitted. Connect the instrument to the serial port on
the host PC, using the supplied cable.
3.
Switch
ON
the instrument and ensure that the side socket is set to RS232 mode and the
computer icon
is lit.
4.
Start the PC software and select Tools
Setup (if the setup dialogue has not started
automatically).
5.
Confirm that the instrument serial number has been read correctly (not shown as “
-
”). This
would indicate that the communications have been established. If not, check settings under
the
“Communication”
tab.
6.
Click on
“Set Time”
to set the instrument clock to the PC clock time.
