GE Healthcare Brivo XR118, Руководство по обслуживанию

Страница: 137 / 318

GE H
EALTHCARE
D
IRECTION
5461425-8EN, R
EVISION
6 B
RIVO
XR118 S
ERVICE
M
ANUAL
Chapter 6 - - Calibration Page 137
Section 2.0
Calibration Sequence
Potential for Data Loss
1.) Always create an up-to-date backup of your system data following product installation or after
making any calibrations.
2.) The system must be reset, upon exiting the Service User Interface for Configuration and
Calibration information to take affect. This must be done before the system is used with patient
acquisitions.
Note: After first installation, those calibrations are needed. Follow the steps below.
Table 6-1 First Installation Calibration
You must always calibrate your system before it can be used and remember to restart your system
after the calibration to active the calibration.
Do backup after calibrations in System Data Backup and Restore
Section 3.0
Invoking New Calibrations
Please restart the system to invoke calibration changes.
The system must be rebooted if changes are made to calibrations files. This includes the creation
of new calibrations and/or the restoration of calibration files. Applications software running on this
system only reads calibration files during workstation boot-up. Any changes after boot-up are not
detected by the applications software.
Section 4.0
Saving Changes
Save changes to calibration files by performing a backup. See System Data Backup and Restore
Tool Calibration/Task Order
Detector Calibration Detector 1
Perform System Reset 2
Image Monitor Setup
Image Monitor Setup with Flat Panel
Monitor
3
PACS / Image Display Test Image PACS / Image Display Test Image 4
Quality Assurance Procedure (QAP) QAP 5
* Numbers in column indicates the order/sequence that the task is performed.