GE H49021AA, Базовое руководство по обслуживанию

Страница: 257 / 420

GE M
EDICAL
S
YSTEMS
D
IRECTION
5184024-100, R
EVISION
5 LOGIQ
WORKS
® B
ASIC
S
ERVICE
M
ANUAL
Chapter 3 Installation 3-191
3-5-10-3 Setting up auto-routing
(cont’d)
2.) Select a destination from the drop-down list, in the Auto Route Basic Teleradiology box.
3.) Click
Send Immediate
, to forward incoming studies immediately to the destination. Click
Transmission Time
, if you want to specify a particular time that incoming studies should be sent,
or
Delay Time
if you want to specify a delay before the studies are sent to the destination. Set the
transmission time or delay time appropriately.
4.) Check the
Delete After Send
check box, to remove the study after it has been sent successfully.
If auto transmission has been set, this will be shown by the indicator in the Send section of the
Teleradiology tool tab.
3-5-10-3-2 Turn off the automatic sending
1.) To turn off auto-routing, select
Configuration -> Auto Routing
from the menu bar in the Data
Selector.
Figure 3-164 Basic Auto Route Parameters
Figure 3-165 Auto Route - turned off