Be careful when moving the refrigerator
away from the wall. All types of floor
coverings can be damaged, particularly
cushioned coverings and those with
embossed surfaces.
Pull the refrigerator straight out and return
it to position by pushing it straight in.
Moving the refrigerator in a side direction
may result in damage to the floor covering
or refrigerator.
When pushing the refrigerator back, make sure
you don’t roll over the power cord or icemaker
supply line (on some models).
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
11
Cleaning the Outside
The door handles and trim.
Clean with
a cloth dampened with soapy water.
Dry with a soft cloth.
Keep the outside clean.
Wipe with a clean
cloth lightly dampened with kitchen
appliance wax or mild liquid dish
detergent. Dry and polish with a clean,
soft cloth.
Do not wipe the refrigerator with a soiled dish
cloth or wet towel. These may leave a residue
that can erode the paint. Do not use scouring
pads, powdered cleaners, bleach or cleaners
containing bleach because these products can
scratch and weaken the paint finish.
Cleaning the Inside
To help prevent odors,
leave an open box of
baking soda in the fresh food and freezer
compartments.
Unplug the refrigerator before cleaning.
If this
is not practical, wring excess moisture out
of sponge or cloth when cleaning around
switches, lights or controls.
Use warm water and baking soda solution—
about a tablespoon (15 ml) of baking soda
to a quart (1 liter) of water. This both
cleans and neutralizes odors. Thoroughly
rinse and wipe dry.
Avoid cleaning cold glass shelves (on some
models) with hot water because the extreme
temperature difference may cause them to
break. Handle glass shelves carefully. Bumping
tempered glass can cause it to shatter.
Do not wash any plastic refrigerator parts in
the dishwasher.
Do not clean with any products containing
detergent, bleach or ammonia. They may
damage the refrigerator.
Condenser
There is no need for routine condenser
cleanings in normal home operating
environments. However, in environments
that may be particularly dusty or greasy, the
condenser should be cleaned periodically
for efficient refrigerator operation.
Removing the base grille:
First remove the base grille. Grasp the base
grille about 6 inches from each end and
pull its bottom edge toward you.
Cleaning the condenser:
Sweep away or vacuum up dust.
For best results, use a brush specially
designed for this purpose. It is available at
most appliance parts stores.
Replacing the base grille:
Replace the base grille by inserting the
tops of the metal clips into the oval vents,
making sure one of the plastic tabs on the
back of the grille goes into each of the oval
vents. Then push the bottom of the grille
forward until it snaps into place.
Behind the Refrigerator
Care and cleaning of the refrigerator.
www.GEAppliances.com
