Appendix A. Command Language Interface (CLI)
46
PACSystems PROFINET Managed Industrial Ethernet Switches User Manual
GFK-3030
Figure 40: Telnet Login Screen
Execution Modes
The CLI contains several execution modes. Users will see different set of commands under different execution
modes. The following table lists all the execution modes and their purposes. When users enter a certain
execution mode, the corresponding mode prompt will be displayed automatically on the screen. The mode
prompts of all the execution modes are also listed below.
Mode
Access Level
Prompt
Init Mode
Guest
>
Enable Mode
Guest
#
Config Mode
Guest
(conf)#
Alarm Profile Config Mode
Engineer
(alarm-profile-conf)#
Gigabit Interface Config Mode
Engineer
(gigabit-intf-conf)#
ACL Profile Config Mode
Engineer
(acl-profile-conf)#
scheduler Profile Config Mode
Engineer
(sch-profile-conf)#
Vlan Interface Config Mode
Engineer
(vlan-intf-conf)#
IGMP MVR Profile Config Mode
Engineer
(igmp-mvr-profile-conf)#
IGMP ACL Profile Config Mode
Engineer
(igmp-acl-profile-conf)#
RingV2 Group Config Mode
Engineer
(ring)#
Trunk Group Config Mode
Engineer
(trunk-group-conf)#
Getting help
The user can g
et help by entering a question mark ‘?’ at each position in the command. The displayed result
depends on the execution mode and previous input.