4
49-6000121 Rev. 0
SAFETY
INFORMA
T
ION
IMPORTANT SAFETY INFORMATION
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
WATER TEMPERATURE ADJUSTMENT
:DWHUWHPSHUDWXUHVDERYH)FDQFDXVHVHYHUHEXUQVRUGHDWKIURP
scalding. Be sure to read and follow the warnings outlined on the label
pictured.
Mixing valves are required for the GeoSpring Solar System. They are used
to reduce water temperature by mixing hot and cold water in branch water
lines. Contact a licensed plumber or the local plumbing authority for further
information.
The chart shown above may be used as a guide in determining the proper
water temperature for your home.
DANGER
There is a Hot Water SCALD Potential if the mixing
valve control temperature is set too high. Households with small
children, disabled or elderly persons may require a 120°F (49°C) or
lower thermostat setting to prevent contact with “HOT” water.
Time/Temperature Relationship in Scalds
Temperature
Time to Produce a Serious Burn
)&
0RUHWKDQPLQXWHV
)&
WRPLQXWHV
)&
$ERXWVHFRQGV
)&
$ERXWVHFRQGV
)&
/HVVWKDQVHFRQGV
)&
/HVVWKDQVHFRQGV
)&
$ERXWVHFRQGV
)&
$ERXWVHFRQG
Table courtesy of Shriners Burn Institute
CAUTION
The GeoSpring Solar System and its pipes and accessories can reach temperatures of up to
)'RQRWWRXFKDQ\SDUWVRIWKHV\VWHPLWVSLSHVRULWVDFFHVVRULHVGXULQJRSHUDWLRQRUZKHQLWLVH[SRVHGWR
sunlight.
WARNING
ELECTRICAL SHOCK HAZARD
Contact with live overhead electrical cables and wiring
can lead to mortal injury.
Work in the vicinity of live, electrical cables and wiring,
where contact is possible, can only be carried out if:
Ɣ
they are voltage-free and it is ensured that they remain
so for the duration of the work to be carried out
Ɣ
the live elements are secured by being covered up or
cordoned off
Ɣ
safety distances are observed
Voltage radius
3.5 ft . . . . .
XSWR9
IW
. . . . . . .
9WR9
IW
. . . . . .
9WR9
IW
. . . . . .
9WR9
!IWLIWKHYROWDJHLVQRWNQRZQ
READ AND SAVE THESE INSTRUCTIONS
Wear protective goggles when
drilling or handling collectors
If no non-personal fall
protection or fall arrest
system or equipment has
been installed for technical
reasons, safety harnesses
must be worn.
Wear cut-proof safety gloves
when carrying out installation
work or handling collectors.
Wear safety shoes when
carrying out installation work
Wear a helmet when carrying
out installation work.
Содержание GeoSpring GT25C10BAM
