•
Where the grounding terminal contacts a painted enclosure panel, scrape the paint
away down to clean, bare metal to ensure a good contact.
3.
Configuration
3.1.
You Will Need:
•
PACSystems RX3i CPU Firmware 8.15 or later.
•
Proficy Machine Edition configuration and programming software, version 8.0 or
later.
•
Serial or Ethernet cable for connecting the Proficy Machine Edition programmer
computer to the RX3i CPU.
•
PACSystems RX3i PROFINET Controller (PNC) module with firmware revision 2.05 or
later or a PACSystems RX3i CPE330 CPU module configured as a PROFINET
Controller
†
.
•
PACSystems RX3i Genius Communications Gateway Module User Manual,
GFK-2892,
also available from the support website. You will need to refer to this manual to fully
configure and commission the GCG001.
3.2.
Basic Configuration Steps
The full configuration of the GCG001 is beyond the scope of this Guide, but is covered in
detail in the User Manual, GFK-2892, referenced in section 4. In brief, the steps are the
following:
1.
If you haven’t already done so, use Machine Edition to add a PROFINET IO-Controller
(IC695PNC001, or PNC001) to the Target’s Hardware Configuration.
†
In the remainder of this guide all references to the PNC001 also apply to the CPE330 when it
is configured for PROFINET.
GFK-2891C
11
