GE EPS 3501 XL, Руководство пользователя

Страница: 17 / 100

17 Electrophoresis Power Supply EPS 3501 XL User Manual 18-1130-22 Edition AD
IT
ALIANO
ESP
AÑOL
DEUT
CH
FRANCE
ENGLISH
5.3 Editing a program
Changing a parameter value
To change a parameter value, move to the start position in SET mode by pressing EXIT
or SET ENTER and choose program number as described on p. 11. If the programming
mode (step or gradient) is changed it will be changed for all the phases within the
program.
Select phase number by
 /

and move in the program with SET ENTER to the value to
be changed. Change with

/

and confirm with SET ENTER. Press EXIT.
Inserting and deleting a phase
Inserting and deleting a phase is described schematically in Fig 6.
Note that you must first enter a phase before it can be inserted or deleted:
1. If needed, change program number by entering the start position in SET mode with
SET ENTER or EXIT, changing the number with  /

and confirming by SET ENTER.
2. Bypass the mode question with SET ENTER.
3. Change to the desired phase number by
 /

and confirm with SET ENTER.
Choose to delete the phase shown on the display or insert a new phase with this phase
number by pressing

/  and confirm with SET ENTER.
If DELETE is chosen, the selected phase will be deleted and the program will move back
to the position with the phase number blinking. Note that by deleting a phase, the
numbers of the following phases will decrease by 1.
If INSERT is chosen, the program will enter the same position and the new phase can be
programmed as a new phase (see section 5.2 and Fig 3, points 4–8). After entering the
breakpoint, the question “Last Phase?” will be bypassed and the starting point for the
next phase will be entered. Note that by inserting a new phase the number for the old
phase with that number and the numbers for the following phases will increase by 1.
Adding a phase after the last phase is done by entering the last phase as above,
moving to the question “Last Phase?” and answering NO. The program will jump to the
start position for programming a phase with the phase number blinking. Proceed with
programming as described for a new program.
It is not possible to insert or delete a phase for a running program.
Editing a running program
See section 5.4
Copying and clearing a program
See section 5.5.
Operation 5