Installation Instructions
7
For Questions on Installation, Call: 1-800-GECARES (US)
Pub # 31-16226
ADDING COVER PLATE TO REAR
OF CABINET (SIDES AND BOTTOM
EXHAUST)
Connect standard metal elbows and ducts to complete the
exhaust system. Cover back opening with a plate (Kit
WE1M454) available from your local service provider.
Place dryer in final location.
PLATE
(KIT WE1M454)
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
10 CHANGING DIRECTION OF
DOOR OPENING
11 SERVICING
WARNING - LABEL ALL WIRES
PRIOR TO DISCONNECTING WHEN
SERVICING CONTROLS. WIRING
ERRORS CAN CAUSE IMPROPER AND
DANGEROUS OPERATION AFTER
SERVICING/INST ALLATION.
For servicing phone numbers for replacement parts, and
other information, refer to Owner’s Manual or visit our
Web site.
WARNING - NEVER LEAVE THE BACK
OPENING WITHOUT THE PLATE.
(Kit WE1M454)
1. Open the door and remove the filler plugs opposite the
hinges. With the door completely open, remove the
bottom screws from each hinge on the dryer face. Insert
these screws about half way into the
TOP
holes, for each
hinge on the opposite side (where you removed the filler
plugs). Apply firm pressure to get the screw started.
2. Loosen the top screws from each hinge on the dryer face
half way. With one hand holding the top of the door and
the other hand holding the bottom, remove the door
from the dryer by lifting it
UP
and
OUT
.
3. Rotate the door 180º. Insert the door on the opposite side
of the opening by moving the door
IN
and
DOWN
until the top hinge and the bottom hinge are resting on
the top screws inserted in step 1.
4. Remove the remaining screws from the side of the
opening from which the door was removed. With these
screws secure each hinge at the bottom. Tighten the two
top screws on each hinge. Reinsert the plastic plugs on
the side from which the door was removed.
TO REGISTER YOUR DRYER
CALL TOLL-FREE
1-888-269-1192
Prompt registration confirms your right to protection under the
terms of your warranty.
www.GEAppliances.com (US)
LOOSEN THE TOP
SCREWS FROM
EACH HINGE ON
THE DRYER FACE
HALF WAY.
REMOVE THE
BOTTOM SCREW
FROM EACH HINGE
ON THE DRYER
FACE.
SECURE EACH HINGE
AT THE BOTTOM AND
TIGHTEN THE TWO TOP
SCREWS OF EACH HINGE.
MOVE THE DOOR IN AND
DOWN UNTIL THE TOP HINGE
AND THE BOTTOM HINGE ARE
RESTING ON THE TOP SCREWS
INSERTED IN STEP 1.
• Insert the elbow through the rear opening and connect it
to the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 6.
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
500A436P007_Rev0
Содержание DSLVR48EH
Страница 8: ...Notes ...
