GE DS-SD4-1, Справочное руководство

Страница: 46 / 76

36 SD Series Reference Manual (x710 Mode) MDS 05-4670A01, Rev. E
RX Tolerance
RXTOL [NORMAL or CUSTOM]
The
RXTOL
command allows custom configuration of the receive toler-
ance, to improve performance with legacy radios (x790, x310, and so
on).
RXTOT [NONE, 1-1440]
Loss of RX Data
Alarm Time
The
RXTOT
command selects or shows the receive time-out timer value
in minutes. This timer triggers an alarm (event 12) if data is not detected
within the specified time.
Entering the
RXTOT
command without a parameter shows the timer value
in minutes. Entering the
RXTOT
command with a parameter ranging from
0 to 1440 resets the timer in minutes. (1440 minutes equals 24 hours.)
Entering the
RXTOT
command with the parameter
NONE
disables the
timer.
SAVECONFIG
Save Configuration
Saves a user configuration. Command is timed and aborts in 3 sec if no
response is provided.
SCD [0-255]
Soft-Carrier Dekey
This command shows or changes the soft-carrier dekey delay in milli-
seconds.
This timer specifies how long to wait after the removal of the keying
signal before actually releasing the transmitter. A value of 0 millisec-
onds will unkey the transmitter immediately after the removal of the
keying signal.
SER
Radio Serial Number This command shows the radio’s serial number as recorded at the fac-
tory (non-configurable).
SHOW [DC, PWR]
Show Power
Settings
The
SHOW
command shows different types of information based on the
command variables. The different parameters are:
•
DC
—Display DC input/output voltages
•
PWR
—Display RF power output
SNR
RX Signal-to-Noise
Ratio
This command continuously shows the signal-to-noise ratio of the
received signal expressed in dB, until you press the Enter key. As used
in this guide, the signal-to-noise measurement is based upon the signal
level following equalization, for received frames.