Issue 1
5-6 Pressure calibrator operation (DPI 620)
K0457 - [EN] English
(2) Set the Leak Test
options
When you have set the
Utility
to
Leak Test
, you can set these
options:
Wait Time:
The time before the test starts in
hours:minutes:seconds (hh:mm:ss)
Test Time:
The period of the leak test in
hours:minutes:seconds (hh:mm:ss)
Note:
To set the Leak Test options, you must have a PM 620
module correctly installed (Section 5.2.3).
5.3.5 DPI 620 calibrator: Set the PM 620 module to zero
Use this option to write a new zero pressure value to the
PM 620 module you are using. This option only affects gauge
type modules.
Note:
To make a temporary adjustment for zero, you can use
the Tare function: Select Settings > Process > Tare (refer to the
user manual - K0449).
2
1
3
4
Select Leak Test
Select Test Time
Steps 5 and 6: Set the Test Time
+ Set the Wait Time (if necessary)
TAP the window
(Maximise)
Select Settings
5
6
7
Start the test and let it
complete.
Go back to the Home window. Start the test
when the pressure system is set up.
Stop the test (with no results)
