Chapter 4. Measuring and Recording Data
DMS Go Operator’s Manual
89
4.1.1
Setting up a Dual Element Transducer (MEASURE - DUAL MULTI)
Note:
This function does not appear if a single-element probe is connected.
The Dual Multi mode is available when a dual-element type transducer is connected to the
DMS Go
. It starts ultrasonic detection from the
zero crossing before a peak echo detected in gate-A and ends with the zero crossing before a peak echo in gate-B. The
DMS Go
calculates
and displays a thickness result value from the acquired data. This mode, sometimes called “Thru-Coating,” is always used with a
dual-element probe to test thickness through painted or coated materials. From the base material, the probe measures between two backwall
echoes. If you have attached a dual element transducer to the
DMS Go
, you should set this option to
ON
.
1.
In the
MAIN
menu, scroll to the
MEASURE
submenu using the joystick (
).
2.
Use the joystick (
) to select the
DUAL MULTI
function.
3.
To change the Dual Multi mode, move the joystick (
) to
ON
or
OFF
.
4.
After completing your selection, move the joystick up or down (
) to navigate away from this function, or press
HOME
to
return to the Main Menu.
Your Complete Source for
Testing Equipment. Since 1969!
www.BergEng.com
Berg Engineering & Sales Company, Inc.
1-847-577-3980
