GE DigitalFlow XGS868i, Руководство по программированию

Страница: 33 / 176

DigitalFlow™ XGS868i Programming Manual 23
Chapter 1. Programming Site Data
1.9.2 Setting Up Inputs and Outputs
Set up the XGS868i’s inputs and outputs via the
I/O
submenu. While following the programming instructions, refer to
Figure 30 on page 79 and Figure 31 on page 80 in Appendix A. The following three submenus are included in this
section:
•
ERROR
- program the meter’s response during an error condition (see below)
•
OPTN
- set up any option cards and the
Slot 0
analog outputs (page 25)
• LCD
- set up the LCD display. Refer to Chapter 2, Displaying Data.
Note:
In this section,
Slot 1
appears as an option only if a suitable option card is installed in Slot 1.
Proceed to the appropriate section to program the option selection made at the above prompt. Remember to record all
programmed data in Appendix B,
Data Records .
1.9.2a Selecting Error Handling
This menu option permits programming of the manner in which the Model XGS868i’s outputs respond during an error
condition. See Chapter 2,
Error Codes , in the Service Manual for a discussion of the built-in error codes. To access this
submenu:
Note:
The 2-Channel meters have an additional option for error handling.
1. In the Keypad Program , scroll to
PROG
and press
[Enter]
.
2. In the
PROG
menu, scroll to
GLOBL
and press
[Enter]
.
3. In the
Global PROGRAM
menu, scroll to
I/O
and press
[Enter].
4. Scroll to
ERROR
and press
[Enter].
5. Scroll to the desired option for error handling and press
[Enter]
. If you select
Error Level in mA
, proceed to Step 6
on the next page. (See Table 1-7 on the next page for a description of error handling options available and how the
totalizers and analog outputs respond to them.)