DDC4500SWH – GE 5.4 Cu. Ft. Large Capacity Modular Commercial Gas Dryer
Specification Revised 8/04
370342
GE Appliances
Dryer Dimensions (in inches)
Exhaust Options:
Shipped with exhaust to the rear.
Gas model
offers 2-way venting: left, right, or rear. Maximum
recommended exhaust duct length is 15 feet of 4" rigid ducting
with two 90° elbows and 4" a dampered wall cap.
(See Installation Instructions.)
Requirements:
Gas
– 115 Volts, 60 Hertz single phase. An individual branch
circuit, properly grounded for a 3-prong outlet, fused for 15- or
20-amp is required for each dryer. Gas rate input, 22000 BTU/
Hr. Maintains the thermostatically controlled heat flow to dry
clothes gently. Longer cool down period on Permanent Press
cycle helps prevent heat-set wrinkles. Separate thermostat
controls lower temperatures for Knit cycle drying. Factory
equipped for natural gas. Tested for LP gas. A conversion kit is
required for LP gas. Check installation instructions for correct
kit number. Have a qualified technician install the conversion
kit. Equipped with energy saving Glo-Bar ignition.
77
27
27
Gas Dryer
only
Cmmrcl. Front.eps
Access
Panel
Access
Panel
11-3/4
41-5/8
3-1/2
3/4
1-7/8
2-3/8
DDC4400S Back View
Dimensions and specifications shown here are correct at the time this sheet was printed. Before
proceeding with construction or rough-in, check installation instructions that came with your unit.
Specifications, dimensions and design are subject to change without notice.
Note:
Wall anchor chain provided for gas models only.
Front View
Rear View
For answers to your Monogram,
®
For answers to your Monogram,
For answers to your Monogram, GE Profi le
™
or
GE
®
appliance questions, visit our website at
GEAppliances.com or call GE Answer Center
®
service, 800.626.2000.
R
Listed by
Underwriters
Laboratories
