GE CGA 351, Руководство пользователя

Страница: 54 / 133

Setup and Calibration 4-15
December 2004
The [Opt-User] Menu
After entering the User Program , access the
[Opt-User]
submenu to
perform the following operations:
•
setting the fault alarm type
•
setting up the analog output
•
adjusting the display contrast
•
setting the display backlight
•
configuring the serial port
Proceed to the appropriate section for specific instructions on the
topic of interest.
Setting Fault Alarm Type
To set up the fault alarm, enter the User Program as described on
page 4-1 and proceed as follows:
Note:
The
[Backlight]
and
[Comm]
options are also available in the
above list box.
Cfg Cal Opt Disp Use the [ ] and [ ] keys to
select
[Opt]
and press
[ENTER]
.
POWER ESC ENTER
Cfg Cal Opt Disp A list of the available options
is shown. Use the [
] and [ ]
keys to select
[User]
and press
[ENTER]
.
User
Setup
Lock Menus
POWER ESC ENTER
User Use the [ ] and [ ] keys to
select
[Fault Alarm]
and press
[ENTER]
.
Fault Alarm
Analog Output
Contrast
POWER ESC ENTER
www.DataSheet4U.com
www.DataSheet4U.com