GE CDWT980RSS - Cafe 24" Tall Tub Dishwasher, Руководство пользователя

Страница: 9 / 48

9
C
o
n
su
m
e
r
S
u
p
p
o
rt
T
ro
u
b
le
sh
o
o
tin
g
T
ip
s
O
p
e
ra
tin
g
In
st
ru
c
tio
n
s
S
a
fe
ty
In
st
ru
c
tio
n
s
GEAppliances.com
Flashing display lights.
Status Indicator Lights What It Means
START/RESET Cycle has been interrupted by pressing the START/RESET pad, or there
has been a power failure. Light will stop flashing after the dishwasher
automatically drains out the water. The dishwasher will restart with
NORMAL
and HEATED DRY if the interruption was the result of a power failure.
Recommended dishwasher products.
GE recommends the following products for use in its
dishwashers:
■ For your manual detergent dispenser, Cascade ®
powder, liquid or gel automatic dishwasher
detergents are approved.
■ For your SmartDispense TM Detergent Dispenser, use
only the recommended liquid automatic detergents
listed on page 12 of this manual.
■ Cascade Crystal Clear ® rinse agents to remove
spots and prevent new film buildup on your dishes,
glasses, flatware, cookware and plastic. Using rinse
agent also improves dry performance.
■ Cerama Bryte ® Stainless Steel Appliance Cleaner
to clean the exterior stainless steel panel of GE and
Profile
TM dishwashers (for stainless steel exterior
models only).
Start
(continued)
Top-Control Dishwashers
After selecting the cycle and desired enhancements, touch the START/RESET pad to ready the
dishwasher to begin the cycle. Close the door to start the cycle or begin the DELAY START countdown.
When the cycle starts, the water fill begins and approximately 60 seconds later the wash action begins.
The dishwasher will always display your last selection and enhancements. If you don’t want to change
the settings, simply touch the
START/RESET pad to ready the dishwasher and close the door to begin
the cycle.
ALL MODELS: If a power failure occurs NORMAL and HEATED DRY will automatically be programmed.
Make any new selections and touch the START/RESET pad to begin the new cycle.
When the door is opened, the indicator lights will turn off if the START/RESET pad is not selected within
5 minutes. To activate the display, open and close the door or touch any pad.
Clean
Front-Control Dishwasher
The CLEAN light will illuminate and a double beep will sound when a wash cycle is complete. On some
models, the CLEAN light will turn off when the door is opened. On other models, the CLEAN light will
remain on until the door is opened and then relatched or until any keypad is pressed while the door
is latched shut.
Top-Control Dishwasher
The CLEAN light will illuminate and a double beep will sound when a wash cycle is complete. The CLEAN
light will remain on until the door is opened and then relatched or until any key is pressed.
ALL MODELS: To turn off the audible end-of-cycle signal (or re-activate it if it was previously turned off),
press the HEATED DRY pad 5 times within 3 seconds. A triple beep will sound to indicate the end-of-cycle
beep option has been toggled.
6
5