GE CARESCAPE, Руководство пользователя

Страница: 456 / 548

Cleaning and care
Cleaning and care points to note
●
Do not let liquid pool around connection pins. If this should happen, blot dry with a
soft, lint-free cloth.
●
Do not use excessive drying techniques, such as oven, forced heat, or sun drying.
●
Do not spray cleaner directly on the display screen.
●
Never connect any device or applied part to a patient until it is thoroughly dry.
Permitted detergents
●
Water.
●
Mild soap.
Permitted disinfectants
●
Ethanol (max. 99.7% by volume).
●
Isopropyl alcohol (max. 60% by weight).
●
Chloramine (max. 5% by volume).
●
Glutaraldehyde (max. 2% by volume).
●
Phenol (max. 2% by volume).
●
Tartaric acid (75 mg per 100 ml solution).
●
Sodium hypochlorite (max. 5.25% by volume mixed with H
2
O in ratio of 1:10).
Cleaning and care instructions
Setting the touchscreen off for cleaning
You can set the touchscreen feature off for 30 seconds at a time when you need to
clean the screen. The countdown timer appears on the screen.
1. Select Monitor Setup .
2. Select Touchscreen Off .
3. You can enable the touchscreen immediately by pressing any monitor hardkey or
the Trim Knob, or by selecting
Cancel in the Touchscreen Off display.
Cleaning non-applied parts, general instructions
Follow these instructions to clean the monitor, modules, display screen surfaces,
EEG headbox, and other non-applied parts unless there are separate part-specific
instructions.
1. Turn off the power to the equipment.
2. Disconnect the equipment from the power supply.
3. Remove all cables and batteries (if applicable) and close battery door(s).
4. Dampen a soft lint-free cloth with one of the permitted detergents or disinfectants.
456 CARESCAPE Modular Monitors 2062971-001