GE 18 Series, Руководство пользователя и инструкции по установке

Страница: 14 / 80

When reversing the door swing:
•
Read the instructions all the way through before
starting.
•
Handle parts carefully to avoid scratching paint.
•
Set screws down by their related parts to avoid using
them in the wrong places.
•
Provide a non-scratching work surface for
the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the hinges from
the right side to the left side—if you ever want to change
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment.
IMPORTANT NOTES
3/8
″
Head socket driver
(a 6-point socket is
recommended)
TOOLS YOU WILL NEED
Phillips screwdriver
Putty knife or
thin-blade screwdriver
Masking tape
T20 or T25 Torx ®
driver, whichever your
model requires
14
On power switch models, set the icemaker power
switch to the
l (on)
position. On feeler arm models,
move the feeler arm to the
ON
(down) position.
The icemaker will not begin to operate until it
reaches its operating temperature of 15°F (–9°C) or
below. It will then begin operation automatically.
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.
Installation Instructions
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
PLUG IN THE REFRIGERATOR
9
START THE ICEMAKER
Feeler Arm in the
STOP (up) position
Feeler Arm in
the
ON (down) position
REVERSING THE DOOR SWING
INSTALLING THE WATER LINE
(CONT.)