Note: Remove batteries when not in use.
II. LIGHT MODE SELECTION:
Press the ON/OFF button to
cycle through to the preferred
light mode (see Fig. 2). This light
offers 3 modes for use: ON (full
brightness), ON (dim), and OFF.
I. LOADING BATTERY:
1. Unscrew the button by twisting the end cap
counterclockwise. A coin or flat screwdriver
(not included) may be used if needed.
2. Push out the inner casing from the tube and
insert 3 AAA batteries (not included), noting the
correct polarity. Insert the casing back into the
tube and screw the end cap back on (see Fig. 1).
LED light wand
User Manual
MADE IN CHINA
GE is a trademark of General Electric
Company and is under license by Jasco
Products Company LLC, 10 E. Memorial Rd.,
Oklahoma City, OK 73114.
This Jasco product comes with a 90-day
limited warranty. Visit www.byjasco.com
for warranty details.
Questions? Contact our U.S.-based
Consumer Care at 1-800-654-8483
between 7AM - 8PM CST.
Fig. 4
III. INSTALLATION:
1. Mount the light in the desired position using the
double-sided tape (included) (see Fig. 3) or by
using a screw (included). Note the diagram in
Fig. 4 for proper installation using a screw.
Fig. 3
• BATTERIES MAY LEAK HARMFUL
LIQUIDS OR IGNITABLE MATERIALS
OR EXPLODE CAUSING INJURY
AND PRODUCT DAMAGE
• DO NOT MIX OLD AND NEW OR
OTHER BATTERY TYPES
• REPLACE ALL BATTERIES AT THE
SAME TIME
• REMOVE BATTERIES IF PRODUCT
IS TO BE UNUSED FOR EXTENDED
PERIODS OF TIME
WARNING
Fig. 1
3 x AAA
Fig. 2
On/Off
button
12747 Manual v4
12/10/18 DM
2. Turn the power on and set the mode you need.
3. Snap the light tube into the stand clip.
IV. FEATURES:
This device can be mounted nearly anywhere,
and can be positioned vertically or horizontally.
Additionally, the light can be detached from the
base to be used as a handheld utility light.
THIS PACKAGE
IS RECYCLABLE
360°
TAPE
