CS875-575-375-275-175 Installers Manual with CS5500 keypad
B.5.5
Some RX8W8, RX16W8 and RX32W8 receivers have DIP switch labels with On/Off rather than Open/Closed
labels. In the table below you can find both references. The label on the receiver always refers to Open/Close (O/
C
).
5.3.3 RF868 Mhz receiver status conditions
When you apply power to the CSx75, the red LED should start blinking. The LEDs on the receiver indicate the
module status.
If you are installing a system in Holland or Belgium, you must use the test antennas RX 9008 when installing
an RF868 system.
For information on installing the RF868 Mhz receiver in the various housings, see chapter A-4
Installing a basic
system
.
Table 5-6: RF868 Mhz receiver DIP switches
DIP switch 1-3
settings
RF
receiver
Module
number
DIP switch 1-3
settings
RF receiver
Module
number
1
34
5
38
2
33
6
37
3
32
(default)
7
36
4
39
8
35
= C (ON)
= O (OFF) DIP switch 4 is not used
Table 5-7: RF868 Mhz receiver LED indications
LED
Module status
Red blinking
Red off
Normal data communication with the CSx75.
No data communication with the CSx75, check the wiring and power
source.
Green blinking
Green off
Receiving radio signals from learn mode wireless sensors.
No radio signals currently being received.
