Installation Guide
Warning:
Check the status of the E39 socket. Poor condition of the socket may result in electrical shock,
overheat or lamp damage. If the socket shows signs of corrosion or arcing as shown in the
pictures, replace the socket and the lamp (if it shows damage)
LED165/M400/740 Tether Kit
Step 2
Slide the U shape steel rod in between the fins. Do not slide the U-shape rod over the LED area.
Step 3
Holding the U shape rod in place, slide the steel ring over the base of the lamp and engage the
threaded portion of the steel rod. Make sure the wings of the steel ring are pointing away from
the base.
Step 4
Feed the provided nuts through the threaded rods on both side of the ring.
Hand tighten using a nut driver or small socket wrench.
(For reference, installation torque between 1 – 3 ft. lbs (2-4 N.m))
GOOD Socket
DAMAGED Socket
DAMAGED Lamp
The wings of the steel ring should be
pointing this way (away from the base)
The U shape steel rod
should be between the fins
