GE HEALTHCARE E-PSMP, Техническое руководство

Страница: 141 / 622

Cardiac Output Modules, E-COPSv, E-COP
4 - 13
2062973-004
Computation constant : 0.542
Measurement Type : Manual
Injectate Volume : 10 ml
Ref Measurement: Deselect
3. Select the TBlood Alarm tab > Setup tab in the C.O. menu and configure:
TBlood Measurement : On
SvO
2
1. Configure the SvO
2
parameter window to the monitor screen with adequate priority.
Simulator configuration
Invasive pressure:
Configure the simulator invasive pressure channels as follows:
Sensitivity : 5
µV
/V/mmHg
InvBP output : "0 mmHg static pressure" or "atmosphere"
Cardiac output:
Configure the simulator's cardiac output channel as follows:
Baseline Temperature/Blood Temperature : 37 °C
Injectate temperature : 0 °C or 2°C
SvO
2:
Turn the SvO
2
simulator's pulsation switch to 'Normal pulse' and the range switch to
'Medium'.
NOTE: Refer to the simulators' documentation for details on how to use and configure the
simulators.
3.3.2 Invasive pressure tests
1. Zeroing
a.
Ensure that the simulator InvBP output channel is configured to "0 mmHg static
pressure" or "atmosphere".
b. Zero the P8 invasive pressure channel by pressing
Zero P4/P8
module key in the
module.
c. Check that a message ‘Zeroing’ followed by a message ‘Zeroed’ is shown in the P8
parameter window.
2. Static pressure
a.
Configure the simulator InvBP output channel to "200 mmHg static pressure".
b. Check that a flat pressure line appears on the P8 waveform field. The reading in the
parameter window shall be 200 ±10 mmHg.
NOTE: Recalibration is needed if the measured value is not within the specification limits.
Calibrate the invasive pressure channels according to the instructions in
4.1. Invasive pressure
calibration section.
3. Pressure waveforms
a.
Configure the simulator's InvBP output channel to "Arterial 120/80".