GE HEALTHCARE CARESCAPE Monitor B650, Техническое руководство

Страница: 79 / 240

Configuration
71
2062973-002
The network configurations will be saved and become active when the patient monitor is
restarted.
7.2.3 Selecting and configuring S/5 Network
To select S/5 Network for the real-time network infrastructure:
1.
Log in to Webmin.
2. Select Configuration > Network > Wired Interfaces .
The current network configuration is shown in the Present Configuration table.
3. Below Select Network Type in the Network Configuration window, select the applicable
network type: S/5 .
4. Select Next to proceed on network configuration.
NOTE: When S/5 Network is selected, the CARESCAPE Network is disabled.
The patient monitor may be configured to the S/5 Network, or IX Network, or both.
1. In the Network Configuration window below S/5 Network , enter a Virtual ID.
NOTE: Valid values are within the range of 50000 to 55000, inclusive.
NOTE: The Virtual ID must be unique for each patient monitor connected to the S/5 Network.
2.
Below IX Network , select DHCP or Manual Configuration .
a. Enter a Static IP address.
b. Enter a valid Netmask level.
c. Enter a valid Default Gateway .
d. Enter valid DNS Server addresses if applicable.
3. Select the applicable Speed & Duplex option.
4. Select Save .
The S/5 virtual ID change will be applied immediately. All other network configurations will be
saved and become active after the patient monitor is restarted.
7.2.4 Configuring WLAN
NOTE: The network infrastructure selection, MC Network or S/5 Network, and related
configuration shall be completed prior to configuring the WLAN settings.
NOTE: Wireless communication is supported only in CARESCAPE Network MC and S/5 Network.
CARESCAPE Network IX does not support wireless communication.
1.
Log in to Webmin.
2. Select Configuration > WLAN . The current status of the WLAN radio is shown below the
Current State in the WLAN Configuration window.
3. Select Enable as a New State to enable the WLAN radio.
NOTE: If the WLAN radio is disabled, the WLAN radio is turned off.
4.
Select Antenna as Enabled to enable both the internal antennas.
Network connection(s) Steps to be performed
S/5 Network only 1 and 4
IX Network only 2, 3 and 4
Both S/5 and IX Network 1, 2, 3 and 4