- 37 -
November 12, 2016
Installation Manual for SX-4000 Standalone
Integrated Media Block™
with Enterprise Storage/Enterprise Storage Plus
7. SERIES 2 PROJECTOR SETUP
7.4. 3D settings for Series 2 projectors
The 3D macros for Series 2 projectors should be configured with the following settings for
“
3D
Input Control
”
:
•
3D Sync Input Mode: Use
[Line Interleave]
(first line=Left, second line=Right)
•
L/R Display Reference: Not Used
•
Frame Rate: 6:2
•
L/R Display Sequence: Left (L1R1 L2R2)
The following shows 3D settings on a Christie projector as an example (see Figure 29).
Figure 29 3D macro settings for Christie Series 2 projectors.
The settings for 3D output control (
[3D Sync Polarity], [Dark Time], [Output Delay]
and
[Phase
Delay]
) should be customized according to the type of 3D system used (RealD, XpanD or
Dolby3D).
If a particular model of the projector is capable of HFR 3D, set up different 3D settings for
different frame rates. This will ensure all channels have a corresponding 3D macro for each
playback frame rate.
For example, the following 3D FRM settings should be set for playback of content at different
frame rates:
Frame Rate FRM setting
24 fpeps 6:2
48 fpeps 4:2
60 fpeps 2:2
