2. SMS
September 26, 2016
SX-4000 Standalone
Integrated Media Block™
User Manual
- 37 -
2.3.5.3. Understanding the SNMP Configuration Interface
2.3.5.3.1. General
Figure 20 SNMP Configuration [General Settings].
1
For
SNMP Manager IP Address
, indicate the IP address of the SNMP Manager where traps are to be
sent by typing in the IP Address , press the
+
or
-
button to insert multiple SNMP addresses.
2
For
Trap Sending Interval
, indicate the time interval in seconds after which a trap should be resent to
the SNMP Manager. The trap will continue to be resent only as long as the error condition exists.
3
For
System UpTime Threshold (days)
, indicate the threshold time in days.
NOTE:
When Trap is On, a trap will be sent if the System UpTime exceeds the threshold value.
4
Activate the Trap by checking the checkbox opposite
SNMP Agent Start
.
NOTE:
When Trap is On, a trap is sent if the SNMP Agent is started.
Deactivate the Trap by un-checking the checkbox next to SNMP Agent Start
.
5
Activate the Trap by checking the checkbox opposite
SNMP Agent Stop
.
NOTE:
When Trap is On, a trap is sent if the SNMP Agent is stopped.
Deactivate the Trap by un-checking the checkbox next to SNMP Agent Stop.
6
Check on the checkbox to enable SNMP Service.
1
6
2
3
4
5
0
