GCC Technologies LaserPro E200 Series, Руководство пользователя

Страница: 11 / 100

10
NOTE
Each LaserPro laser machine is shipped with a single pair of safety goggles. If additional
safety goggles are required, please contact GCC directly or an authorized GCC
distributor. If you wish to purchase one on your own, please make sure the safety
goggles meet these requirements:
9000-11000nm OD5+
Visible Light Transmission: 92.9%
1.5 Safety Measures
•
LASER RADIATION WARNING : Exposure to laser radiation may result in physical burns and
severe eye damage. Proper use and regular maintenance of this machine is important to the
safety of all people in the immediate area.
• Prior to operation, carefully read and familiarize yourself with the warning labels located on
both your laser system and in this manual.
• Never leave the machine unattended during the laser cutting and engraving process. The laser
may ignite combustible materials. A well-maintained fire extinguisher and operational smoke or
fire detector should be kept in the vicinity of the machine.
•
Caution
—Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
• GCC cannot be held responsible for any direct or indirect damages, which result from using or
working with the products electric circuits or software described herein. The apparatus must be
used only by trained and skilled personnel. Before using the machine, user should read and
follow the manuals carefully. Furthermore GCC reserves the right to change or alter any product
described herein without prior notice.
• Resulting debris from laser cutting are very dangerous and may cause fire hazard.
 DO NOT leave debris and scraps inside laser machine after job finished. Must keep
machine clean after job finished.
WARNING
・
Resulting debris from laser processing are very dangerous and may cause fire hazard
・
DO NOT leave debris and scraps inside laser machine after job finished. Must keep
machine clean after job finished.
・
Always remove the vector grid or honeycomb table to clean any small pieces that have
fallen through the grid.
• Connect the machine to a properly grounded power outlet. Ensure the voltage of the power
source is identical to the voltage of the machine.
• Do not open the laser access panel when the machine is plugged in.
• Do not attempt to modify or disassemble the laser module.
• Do not attempt to remove or modify any component of the machine’s laser interlock safety
system.
• Ensure the immediate work area of the machine is well-ventilated. Odors, vapors, and dust are by
products generated during the laser engraving and cutting process. An exhaust system, vacuum
cutting box, and honeycomb table are recommended. Please contact GCC or your local GCC
distributor for more information.
• Do not laser heat-sensitive surfaces or materials that may generate toxic fumes, such as PVC and
Teflon

Regularly clean and maintain your machine according to our cleaning and maintenance
instructions. Doing so will ensure a machine that will operate effectively and safely over a long
period of time.