10
Elite XL Sheet Feeder Installation Guide
13. Plug the power cord into the wall outlet.
14. Switch on the printer.
15. Refer to Appendix D in the Elite XL User’s Manual for information
about printing with additional sheet feeders.
Removal Procedure
To remove a sheet feeder from the Elite XL printer:
1.
Switch off the printer and unplug the power cord from the AC outlet.
2.
Disconnect the power cord and all interface cables from the back of the
printer.
3.
Remove any paper trays from the printer and sheet feeder(s).
4.
Remove four retaining clips.
Remove the four plastic clips locking the feeder in place. The clips are
located at the four inside corners where the sheet feeder mates with the
printer.
5.
Remove the sheet feeder control cable cover.
The control cable cover is located at the lower left corner of the back of the
sheet feeder. To remove the cover, grasp the cover’s handle, push it up, then
pull it out. With the cover removed, the control cable will be visible.
6.
Remove the control cable cover from the printer.
The control cable cover is located at the lower left corner of the back of the
printer or sheet feeder. To remove the cover, grasp the cover’s handle, push
it up, then pull it out. With the cover removed, the control cable will be
visible.
7.
Disconnect the control cable from the printer.
Grasp the control cable close to the connector and pull gently until the cable
is released.
8.
Detach the sheet feeder from the printer.
Slowly lift the printer from the sheet feeder.
9.
Replace all of the control cable covers.
