Power
Box
Motocycle
Ignition Switch
Battery
Power Box
Power+
Power+
Power-
Battery-
Power-
Motocycle
Power Ground or
Battery Ground
MOTO CAM User Manual
Fasten Points
Adjustable Lens
Micro USB
Port (P.9)
USB Port
(P.8)
Power Box
Wiring Diagram
Record Button
Record Light
Wi-Fi Light
Power Light
Wi-Fi Button
Power Button
Control Panel
Main Device
1
2
3
3
2
1
1
、Place the 3M VHB tape onto the Metallic mount.
2
、Stick the silica gel patches between the mount and the joints, then screw in the screws.
3
、Stick the silica gel patches between the main device and the joints, then screw in the screws.
4
、Make sure to clean the surface of where you want to install the mount to, and rip off the other side of the 3M tape
and stick it to the said surface, and press for at least 5 seconds when applying the mount.
5
、Adjust the main device and the joint to desired positions, then screw down the screws tight.
6
、If the surface you are installing to is curved, please bend the mount to fit the surface.
3M VHB
Tape
Metallic Joint
x 2 pcs
Main Device
Fine Thread
Hex Head Screw x2 pcs
Silica Gel Patches x4 pcs
Metallic Mount
Coarse Thread
Hex Head Screw x2 pcs
Installation Diagram
