GBC StreamWire, Руководство по обслуживанию

Страница: 402 / 455

GBC StreamWire 07/23/2020 General Procedures and Information
6-65
15. Confirm that the spool is installed properly.
a. Is the rewind paper secured to the Rewind Hub and taut?
b. Is the wire fed loosely across the wire shield?
c. Is there one row of slack wire beneath the spool, in contact
with the bottom of the Element Feeder Drawer?
d. Is the end of the wire in line with the mark on the Element
Guide Nose, just in front of the Knife?
e. Is all the spool packaging and the flexible magnet removed?
16. Slide the Element Feeder Drawer back into the eWire and close the
door.
GP 6.8 Supply Spool Removal
Do the following procedure to remove a partially full supply spool from the
eWire. If the spool is empty, the same general procedure can be used but
there is no need secure loose wire to the spool.
1. Stop the Printer/Copier. Open the eWire access door panel and slide
the Element Feeder Drawer out.
2. Turn the Knob counterclockwise to release the wire loose end from
the Element Feeder.
3. Lift slack wire from the metal wire guide surface and place it against
the magnetic catch. This will hold wire out of the way during
replacement.