GBC Spire III 44T, Инструкция по эксплуатации

Страница: 21 / 49

SPIRE III Series
– Installation and Operating Instructions
Page 5-6
r
ear
t
aBle and
o
ptIonal
I
dler
Figure 16. Rear Table and Optional Idler.
a. r
ear
t
aBle
The Rear Table supports the media as it exits the
machine.
B. o
ptIonal
r
ear
t
aBle
I
dler
The Optional Rear Table Idler is part of the Rear
Table and assists the web as it exits the laminator.
p
Hoto
s
aFety
s
ensor
, G
ap
G
auGe
, t
aBle
a
lIGnment
k
noB
Figure 17. Components on right side of Feed Table.
a. p
Hoto
s
aFety
s
ensor
The Photo Safety Sensor helps prevent
entanglement, entrapment, and inadvertent contact
with the rollers. The Sensor is located on the right
side of the machine, in front of the Bottom Main
Roller. Its reflector is at the opposite end of the Feed
Table. The Sensor stops the machine when a hand or
object blocks the invisible beam if you are not using
the Footswitch.
To return to normal operation after the obstruction
has been cleared, press
RUN
.
WARNING : Using the Footswitch overrides
the Photo Safety Sensor and the speed
drops to 3 fpm (0.9 m). When the Footswitch is
released, the laminator stops.
B. G
ap
G
auGe
The Gap Gauge indicates the amount of gap
between the Main Rollers. Use the Gap/Pressure
Crank to adjust the gap.
c. t
aBle
a
lIGnment
k
noB
The Table Alignment Knob ensures that the table
is properly aligned with the Main Pressure Rollers.
Adjustment must be made by service personnel only.
p
ressure
p
late
The Pressure Plate helps keep prints flat while being
fed into the rollers. The pressure Plate must be
removed before raising the Feed Table.
Figure 18. Pressure Plate.
WARNING
: Rollers may be hot. Take care
not to touch rollers while removing or
installing the Pressure Plate.