GBC Spire III 44T, Инструкция по эксплуатации

Страница: 15 / 49

SPIRE III Series
– Installation and Operating Instructions
Page 4-2
l
ocatIon
Provide adequate space around the laminator as
shown in the illustration.
The laminator should be located so that exiting film
drops freely to the floor or to a table that is lower
than the exit point of the laminator. Accumulation of
laminate immediately behind the laminator as it exits
the equipment may cause the film to wrap around the
rollers, jamming the machine.
Avoid locating the laminator near sources of heat or
cold. The laminator should not be in the direct path
of forced heated or cooled air.
20 ft.
(508 cm)
Front
3 ft.
(91 cm)
Rear
8 ft. 8 in.
(220 cm)
8 ft. 8 in.
(220 cm)
13 ft. (330 cm)
Electric cord
drop
6 x 6 ft.
(183 x 183 cm)
Work table
on wheels
6 x 6 ft.
(183 x 183 cm)
Work table
on wheels
Figure 3. Laminator location dimensions.