© GBC Pro - Tech August 1999
Page 6 - 102
F - 160 Operation and Maintenance Manual
Applications
Parameter Chart 3 - Single sided ( Sled )
T E M P E R A T U R E
GAP & PRESSURE
MOTOR DIRECTION & SPEED
T O P T E M P .
B O T . T E M P .
P R E S S U R E
G A P
S P E E D
F W D
R E V .
G O
G O
= Panel
SOLID
F L A S
H I N G
= Footswitch
PULL ROLL SETTINGS
N O T E S
N / A
1/4 Turn
1/2 Turn
3/4 Turn
P R E S S U R E
MATERIALS
U P P E R U N W I N D :
L O W E R U N W I N D :
S U B S T R A T E :
P R I N T S :
Pro Gloss
N / A
1 / 4 " F o a m C o r e
Inkjet prints
6 8
6 8
1/4
00.0
Substrate will vary. Print can be of any type. GAP will be dependent on the substrate thickness. Pressure will
be determined by operator. Speed is not indicated in Footswitch mode. Because the process is described
from the front of the laminator, motor direction is FWD and the pull rolls are not required for this application.
D O W N
U P
