Chapter 2
27
Main
The Main screen allows the user to set the system time and date as well as enable and disable boot option
and recovery.
NOTE:
The screen above is for your reference only. Actual values may differ.
The table below describes the parameters in this screen. Settings in
boldface
are the default and suggested
parameter settings.
Parameter
Description
Format/Option
System Time
Sets the system time. The hours are displayed with 24-
hour format.
Format: HH:MM:SS
(hour:minute:second)
System Date
Sets the system date.
Format MM/DD/YYYY
(month/day/year)
System Memory
This field reports system memory size.
N/A
Total Memory
This field reports the memory size of the system.
Memory size is fixed to 4096MB.
N/A
Video Memory
Shows the video memory size. VGA Memory size=32 MB
N/A
Quiet Boot
This will hide POST messages while booting.
Option:
Enabled
or Disabled
Network Boot
Enables, disables the system boot from LAN (remote
server).
Option:
Enabled
or Disabled
F12 Boot Menu
Enables, disables Boot Menu during POST.
Option:
Enabled
or Enabled
D2D Recovery
Enables, disables D2D Recovery function. The function
allows the user to create a hidden partition on hard disc
drive to store operation system and restore the system
to factory defaults.
Option:
Enabled
or Disabled
SATA Mode
Control the mode in which the SATA controller should
operate.
Option:
AHCI
or IDE
I t e m S p e c i f i c H e l p
T h i s i s t h e h e l p f o r t h e
h o u r f i e l d . V a l i d r a n g e
i s f r o m 0 t o 2 3 .
I N C R E A S E / R E D U C E : F 5 / F 6
F 1
E S C
H e l p
E x i t
S e l e c t I t e m
S e l e c t M e n u
C h a n g e Va l u e s
S e l e c t
S u b M e n u
E n t e r
F 9
F 10
S e t u p D e f a u l t
S a v e a n d E x i t
[ 1 9 : 1 0 : 5 9 ]
[ 0 6 / 0 9 / 2 0 0 9 ]
6 4 0 K
4 0 9 6 M B
[ 6 4 M B ]
[ E n a b l e d ]
[ E n a b l e d ]
[ D i s a b l e d ]
[ E n a b l e d ]
[ A H C I M o d e ]
[ 1 9 :
1 0 : 5 9 ]
[ 0 6 / 0 9 / 2 0 0 9 ]
6 4 0 K
4 0 9 6 M B
[ 6 4 M B ]
[ E n a b l e d ]
[ E n a b l e d ]
[ D i s a b l e d ]
[ E n a b l e d ]
[ A H C I M o d e ]
S y s t e m T i m e :
S y s t e m D a t e :
S y s t e m M e m o r y :
T o t a l M e m o r y :
V i d e o M e m o r y :
Q u i e t B o o t
N e t w o r k B o o t
F 1 2 B o o t M e n u
D 2 D R e c o v e r y
S A T A M o d e
S y s t e m T i m e :
S y s t e m D a t e :
S y s t e m M e m o r y :
T o t a l M e m o r y :
V i d e o M e m o r y :
Q u i e t B o o t
N e t w o r k B o o t
F 1 2 B o o t M e n u
D 2 D R e c o v e r y
S A T A M o d e
F 5 / F 6
I n s y d e H 2 0 S e t u p U t i l i t y R e v . 3 . 5
Boot
Exit
Security
Information
Main
Содержание EC14
