Gateway E-9520T, Руководство пользователя

Страница: 70 / 126

CHAPTER 5: Using the BIOS Setup Utility www.gateway.com
64
8
Remove the jumper from pins 1-2.
9
Follow the instructions in “Closing the server case” on page 30 .
Resetting BIOS passwords
To reset BIOS passwords, you must either reset and clear all BIOS settings, or
use the Clear Password jumper. To reset all BIOS settings, follow the instructions
in
“Resetting the BIOS” on page 63 .
To clear the BIOS password(s):
1
Follow the instructions in “Preventing static electricity discharge” on
page 28 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
Caution
Moving the jumper while the power is on
can damage your server. Always turn off
the server and unplug the power cords
and all other cables before changing the
jumper.
2
Follow the instructions in “Opening the server case” on page 29 .
3
Install a jumper across pins 1-2 of header J59-A.
4
Follow the instructions in “Closing the server case” on page 30 .
5
Reconnect the power cords and turn on the server. The BIOS password(s)
is cleared.
6
Turn off the server, then disconnect the power cords and all other cables
connected to the server.
7
Follow the instructions in “Opening the server case” on page 29 .
8
Remove the jumper from pins 1-2.
9
Follow the instructions in “Closing the server case” on page 30 .