Gateway E-9520T, Руководство пользователя

Страница: 62 / 126

CHAPTER 4: Installing Components www.gateway.com
56
Replacing the system board
To replace the system board:
1
Follow the instructions in “Preventing static electricity discharge” on
page 28 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2
Follow the instructions in “Opening the server case” on page 29 .
3
Set the server on its side to make it easier to work on.
4
Remove the PCI expansion cards by following the instructions in “Installing
and removing PCI expansion cards” on page 41 .
5
Remove the memory modules by following the instructions in “Installing
memory” on page 38 .
6
Remove the heat sinks and processors by following the instructions in
“Replacing or adding a processor” on page 46 .
7
Disconnect all cables from the system board, noting their locations and
orientation. (You will reconnect the cables after you install the new board.)
8
Loosen the two thumbscrews (2) that secure the system board to the
server.
2
1
1
1
1
1