Gateway ALR 9250R, Руководство пользователя

Страница: 29 / 226

Chapter 1: Getting Started 15
Powering up the system
Lift the plastic cover over the power switch on the front panel and press it,
and the green LED immediately beside the power switch turns on.
If you turn off the server, you must wait at least ten seconds before you turn
it back on.
The system self-checks the memory even if the monitor is not connected. If
the monitor is connected and powered on, the screen displays the power-up
sequence.
•
If more than one CPU is installed, the system displays which CPU
it is currently testing.
•
If any errors are encountered, the server displays them on the
monitor.
•
If a monitor is not connected or the system is unable to display an
error, it sounds an error beep code.
•
If the system encounters an error, it is usually a nonfatal error,
meaning the system continues to function until the error is
corrected (usually through the BIOS Setup). In the rare case of a
fatal error, contact Gateway for field service support.
Looking things over
Sometimes the simplest things can cause trouble. Before powering up the
system, perform the following checks:
•
Are the power cords connected to the CPU system drawer and an
appropriate power source?
•
Is the power source supplying power?
•
If a power strip is used, is it switched on? Is the circuit breaker set?
•
Does the voltage selection switch on the system’s power supply
reflect the proper voltage?
Warning!
The top cover must be
closed and secured while
the system is running.
!
Note:
Under no circumstances
return any equipment
without obtaining a Return
Material Authorization
(RMA) number.
9250R.book Page 15 Friday, April 9, 1999 9:44 AM