Gateway 9515, Руководство пользователя

Страница: 44 / 194

39 www.gateway.com
12
Remove the PCI riser assembly.
13
Move the shorting block on the Boot Block jumper (J1B1) back to pins 2-3.
14
Replace the PCI riser assembly.
15
Follow the instructions in “Closing the server case” on page 46 .
Updating the FRU/SDR
The FRU/SDR must be updated whenever you add additional hardware to your server
that must be monitored by the BMC. This includes adding a redundant power supply
module, adding redundant hot-swap fans, or adding an Intel Management Module
(IMM). The FRU/SDR must also be updated whenever you update the BIOS.
Each time you update the FRU/SDR, we recommend that you check
support.gateway.com for the most current version of the utility. If a newer version is
available than the one included on the SCCD, download the newer version and use
it instead of the SCCD in the following procedure.
To update the FRU/SDR:
1
Boot your server to DOS (using a DOS-bootable diskette, CD, or USB disk on key).
2
Put the System Companion CD (or a CD with the FRU/SDR utility on it) in the CD
drive.
3
When the menu opens, select the FRU/SDR utility.
4
Select one of the following options:
Update just the SDR repository
- Select this option when sensor information needs to
be changed. For example, if the CPU is upgraded to a higher speed or if memory is
replaced.
-OR-
Update the FRUs and the SDR repository
(and mBMC TBLs - if the IMM module is not
present) - Select this option if have installed additional hardware. For example, a
redundant power supply or system fans, or additional memory.
5
You will be asked if you have an optional cooling kit installed. Type Y if your system
has redundant fans installed, or N if you system has only the basic fans installed.
6
Exit the utility, remove the System Companion CD, and reboot your server.