Gateway 820 LTO, Руководство пользователя

Страница: 41 / 72

37
Autoloader operations
www.gateway.com
Resetting the autoloader
A reset causes the autoloader to perform its power-on self-test (POST) and check
for the presence of data cartridges. You can reset the autoloader in any of the
following ways:
■
Power-on reset — Turning the autoloader off (or unplugging it), then
turning it back on again resets the autoloader and the tape drive.
■
Operator’s Panel — Select the
Configuration
menu, press E
NTER
, select
Reset
,
then press E
NTER
. For more information on using the Operator’s Panel, see
“The Operator’s Panel” on page 13.
Resetting the tape drive does not eject a cartridge loaded in the drive. If a
cartridge is in the tape drive during a reset, make sure that it is safe to overwrite
the loaded cartridge before performing a backup. If you perform a backup
without checking the loaded cartridge, you may lose important data from a
previous backup.