Gateway 205, Руководство пользователя

Страница: 34 / 50

30
Using the Gateway 205 Projector
www.gateway.com
11
Turn the projector over.
12
Connect the power cable and all external cables.
To reset the lamp timer:
1
Press the POWER button on the top of the projector twice, a warning
message appears.
2
Press the AUTO and BLANK buttons at the same time. A lamp hour icon
will appear on the screen.
3
Press the AUTO button to reset the lamp timer.
Cleaning the projector
Keeping the projector clean and the vents free from dust helps keep it
performing at its best.
Cleaning the exterior
Always turn off the projector and wait for it to cool before cleaning it.
Use a damp, lint-free cloth to clean the projector case. Do not use abrasive or
solvent cleaners because they can damage the finish.
The projector is cooled by air circulated through the vents on the case, so keep
the vents free of dust. With the projector turned off and unplugged, brush the
dust away from the vents with a damp cloth. Be careful not to drip any water
into the vents. Do not attempt to clean dust from the inside the projector.
Cleaning the projector lens
Always turn off the projector and wait for it to cool before cleaning the projector
lens.
Use a soft cloth and glass cleaner to clean the projector lens. Squirt a little
cleaner on the cloth (never directly on the lens), and wipe the lens with the
cloth.
Warning Make sure that the projector is off, power is disconnected,
and the lamp is completely cool (minimum of 45 minutes)
before cleaning the projector.