Gates UNIPRESS 4, Руководство по эксплуатации

Страница: 25 / 54

25
GATES.COM
UNIPRESS 4 (UP4)
OPERATION MANUAL
4.3.2 DESCRIPTION OF THE SETTING PARAMETERS
Parameter display Pressure indicator Operation indicator
Operation button with
press and twist function
BASICS
The required parameter is indicated after twisting the knob. If you press the knob, the selection is actuated,
the parameter variable (P, L, F, A) starts to blink. The value is set by turning the knob in the required direction
in increments of ten. Changing the direction alters the intervals to increments of one. The first catch when
twisting does not change the value in order to prevent accidental altering.
Parameter adjustment is stopped by pressing the button. If no further values are changed, it stops
automatically after 6 seconds.
From the parameters F (back stroke) and A (absolute counter), the indicator leaps back to pressure indication
by itself. The lot size counter can be displayed permanently.
OPERATION MODE PRESSURE ADJUSTMENT
Which pressure (P) you have to set can be taken from the table of values.
The piece counter (C) can be adjusted up to 999 and counts backwards.
The cycle time is optimised by limiting the back stroke (F).
The absolute counter serves for maintaining the service intervals.
OPERATION MODE AUTOMATIC PRESSURE ADJUSTMENT
Via list selection (L), up to 7 programmed pressure tables which select the pressure according to the inserted
presetting plate can be called up. When you select the list, the key switch must be set to “List” position.