Y58
User Manual & Install Guide
119 of 148
playback (in seconds) when the alarm
occurs.
Alarm Snap
–
checkbox
–
if selected,
when the alarm occurs, the device will
take snapshots using the selected
cameras.
DEFAULT SETTINGS:
Please choose the camera channels to display
and record in the event of this alarm being
triggered. These settings would need to be
determined by the customer/client to match
their specific business requirements.
6.5.5
Driver Alert Button: Setup
A Driver Alert Button is available as an optional accessory for the Y58. The
Driver Alert Button must be installed using the provide Tek screws. The Driver
Alert allows for the driver of the vehicle to press the button and mark the
recorded video with an Alert. This makes searching for Alerts far faster and
easier as G4 Viewer Plus can be set to display Alarms/Alerts.
The Driver Alert Button requires setting up in the configuration of the Y58
Navigate to Setup Alarm Button Alarm. Check the Enable box.
Alarm Type should be set to Alarm.
Trigger relates to the amount of time, in seconds, of pre-recording will be included from when the
Driver Alert button was pressed.
If the Driver Alert button has been pressed during the vehicle’s route this alert will be easy to find
using Gatekeeper Systems G4 Viewer Plus when playing back the video on a PC.
Serial Port Settings.
Tri- Colour Driver Alert 485-1
Control Panel
57600
6.5.6
Video
Navigate to:
Main Menu Setup Alarm Video
This subsection enables you to set up the trigger for alarm events based on video loss, and also to
define the actions that will be taken when the alarm occurs.
