Y35 HD v3
User Manual & Install Guide
120 of 156
▪
Channel
–
checkboxes that allow you to select any
combination of the camera channels to be included in
the display and recording.
▪
Pre Recording
–
numeric value box which allows you to
enter the duration for which video will be recorded prior
to the alarm being triggered.
▪
Post Recording
–
numeric value box which allows you to
enter the duration for which video will continue to be
recorded when the alarm is triggered.
▪
Lock
–
checkbox, if selected will mark the recorded video
associated with this alarm as a locked video.
▪
Linkage IO Output
–
checkboxes, if enabled, the device
will send a signal to the selected IO output lines.
▪
Output Delay Time
–
numeric text field to set the delay
time for the IO output (in seconds).
▪
Linkage Screen
–
drop-down list to select the options to
display the video from the selected cameras on-screen
when the alarm occurs.
None :
Not displayed
Single :
Display 1 camera.
Double :
Display 2 cameras.
Quad :
Display 4 cameras.
If Single (1x1), Double (2x1) or Quad (2x2) display is selected, the
(Setup)
button allows you to select the layout of the channels to
be displayed on-screen.
The drop-down lists are shown on-screen according to the grid
layout mode selected. You can easily choose each individual
camera channel to be displayed in the selected grid segment
visually. If you have less cameras than available grid segments,
then those segments associated with an actual camera will be
displayed as a black box.
▪
Alarm Image Upload
–
checkbox, if selected will enable
the device to upload the alarm to the center server
6.5.9
Advanced
Navigate to:
Main Menu
→
Setup
→
Alarm
→
Advanced
This subsection enables you to set up the trigger for alarm events based on ACC input, and also to
define the actions that will be taken when the alarm occurs.
