Velox to G-Shield Fire Upgrade Kit Instructions
13
Version 3
P/N 761011-02
12. Sensor Platform Maintenance
You will notice some resistance as air is expelled from between the G-Pod and the Sensor
Platform. This is normal.
Note:
Do not over tighten the grubscrew. The grubscrew can damage the threads on the
Sensor Platform.
CAUTION:
Sensor Platforms are supplied without a G-Pod installed. Make sure you install a
G-Pod.
CAUTION:
Figure 23. G-Pod key.
Figure 24. Sensor Platform keyway.
Figure 25. Sensor Platform Bushing Nut.
Align the key on the G-Pod with the keyway on the Sensor Platform. Push the
G-Pod into the Sensor Platform.
Step 1.
Fit the bushing nut. The Bushing Nut attaches the G-Pod to the Sensor Platform.
Step 2.
Step 3. Tighten the grubscrew using the 1.3mm hex wrench supplied in the upgrade kit.
Grubscrew
13. G-Pod Installation
Do not try to attach the Splash Guard when a Dummy Plug is installed as it will not fit.
CAUTION:
Make sure you replace the G-Pod with a Dummy Plug (P/N 65-2000-00) during
maintenance.
Step 1.
