8
TEST FIRING OUTDOOR GAS FIRE PIT
Test fire appliance, following the lighting instructions. Leak test all gas connections with soapy water. Soap bubbles
indicate gas leakage. DO NOT use a match to test for gas leaks. WARNING: White smoke may appear around the burner
during the first minutes of the initial firing.
TROUBLE SHOOTING
Problem
Possible Causes
Solution
Burner will not
light
No gas
Replace cylinder
Low gas pressure
Replace cylinder
Blockage in orifice
Remove blockage
Faulty thermocouple
Authorised service
Note: If the appliance cannot be adjusted to perform correctly it should not be used until serviced or repaired.
White smoke may appear around the burner during the first minute of initial firing.
Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage.
Any modifications or adjustments made to the appliance without prior authority from the manufacturer will void
any warranty claims. Read the installation, operating and maintenance instructions thoroughly before installing or
servicing this equipment.
WARNING
LIGHTING INSTRUCTIONS
WARNING: White smoke may appear around the burner
during the first minutes of the initial firing.
1. Ensure that the control knob is off. Slowly open the
gas cylinder valve.
2. Push in control knob and turn anti-clockwise to
LOW / IGNITION whilst simultaneously pressing the
red ignitor button.
3. Check the flame. If it does not light immediately turn
control knob to OFF position and try again from the
start. Allow 30 seconds between ignition attempts
for gas to dissipate. Several attempts may be
necessary.
Failure to follow this lighting procedure may
result in flame roll out.
4. With flame alight keep control knob depressed for
20 seconds.
5. For minimum flame turn the control knob to LOW.
6. For maximum flame turn the control knob to HIGH.
7. To turn fire pit off, turn the control knob to LOW,
push in the control knob and turn to OFF.
OFF
HIGH
LOW