9
GENERAL ASSEMBLY
CONNECTING & DISCONNECTING
TO GAS SOURCE
Familiarise yourself with the general information
and safety guidelines located at the front of
this manual.
CONNECTION
1. Gas cylinder is filled. A sloshing sound will
be heard when shaken.
2. Connect the Regulator to the cylinder valve
and tighten (PIC. 4).
3. Check for any damage to either the cylinder
connection or the hose. NEVER attempt
to use damaged equipment.
4. Turn the gas cylinder valve on (PIC. 5) and spray
soapy water on all connections to check for leaks.
If a leak is detected turn the valve off, retighten
all connections and retest.
GENERAL POSITIONING
1. Never place or position the cooker on combustible
material. Only use on a non-combustible surface.
2. Ensure the gas hose is straight and not kinked.
LIGHTING THE COOKER
ADJUSTING HEAT OUTPUT
1. Turn the gas control in a clockwise direction to
achieve a higher flame and in the anti-clockwise
direction for a lower flame or to turn off (PIC. 6 & 7).
Note: Locate the gas cylinder away from your cooker
to ensure it is not subjected
to radiant heat.
2. Gas Valve “ON” Max.
The gas lever is in a straight
line with the gas valve to
the venturi tube.
AERATION
To ensure the flame is clean and blue, that is NO
yellow tip to flame or sooting, adjust the primary air
disk. The primary air disk can be adjusted clockwise/
counter clockwise by hand. The ideal positioning
of the aeration disk when measured from the venturi
tube is 1-2mm open.
PIC. 6
PIC. 4
PIC. 4
PIC. 7
PIC. 5
