GAS GAS MC 85 2023, Руководство пользователя

Страница: 102 / 176

16 SERVICE WORK ON THE ENGINE
100
16.1 Checking the gear oil level
Condition
The engine is cold.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
S04352-10
Main work
–
Remove screw
1
with the seal ring.
–
Check the gear oil level.
Gear oil must not run out of the hole.
The gear oil level is at the lower edge of the hole.
» If the gear oil level is below the hole:
–
Add the gear oil. ( p. 101)
» If gear oil runs out:
–
Correct the gear oil level.
–
Mount and tighten screw
1
with the seal ring.
Guideline
Screw, gear oil level
monitoring
M6 8 Nm (5.9 lbf ft)
16.2 Changing the gear oil
Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the appli-
cable regulations.
Info
Drain the gear oil while the engine is at operating temperature.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
–
Position an appropriate container under the engine.
S04352-11
Main work
–
Remove oil drain plug
1
with the magnet.
–
Let the gear oil drain fully.
–
Thoroughly clean the oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten oil drain plug
1
with the magnet and a new
seal ring.
Guideline
Oil drain plug with
magnet
M12 20 Nm (14.8 lbf ft)